Allright fellas *and ladies*
Im sure youve all seen the pics of the NB i got sent to re-do:
Sure, it may not look
too bad here, but in person it's crap.
Ready?
'ere we go! Step 1: He's in love witha stripper
*Go west young man, and buy in quality*
Tried goo gone, but alas; with 30 coats of varnish it just didnt do it.
This did tho!
This stuff cost @$4 US, worked in 20 min, bottled it for re-use. *I highly recommend it!
Step 2: Hot Flashes... Cold Feet
*sorry no pic*
Dropped poor C'tan in boiling kettle for @1 min.. then into Ice water.
Any guesses why?
AAH-SO Grasshopper, that's right;
easy way to break Super-glue off *and out*
Step 3: Chisel me timbers... err... limbs
*no in process pic*
Use an xacto *carefully* and drill, pliers, small chisel, file...
to pry, chip, and remove surplus SG
Heres the parts: *torso still attached at this point*
Step 4: Bondage "Chains and WIPs are a Ghouls best friends!!"
Now I RE-ASSEMBLE all of the parts
Step 5: Mind the gap!
Whew... forgot how bad this mini was cast!
Lookit all the stuff that has to be GSed...
*the origional was filled w/ SG*
Shoulders/Pits
Torso/Crotch
Hole in arm from original pin
*or sin* 
Step 6: Its easy doin green.... *screw you Kermit!!*
Well now... Ive been asked before to detail the steps..
SO HERE! 1: Getchur toolz 
2: Pull = amounts of putty 
3: Mix to consistant color
*dont copy my fingerprints... trust me; You DONT want em!*
4: Time to make the sausage.
roll out a thin line.
5: Stuff yur sausage
Put it where the sun shouldnt shine and use your toolz to press it in.
6: Smooooooth!
Use your tools to smooth out the GS and add texture if needed.
Dont worry if its a little scrappy, you should go back when its completely set to file anyway.
Too many pics for one post! Will be Continued!!!